Thread: Get different heads or???
Threaded View
-
02-28-2004 12:09 PM #1
Get different heads or???
Hi,
New guy here, but this looks like the place for good answers!
Just picked up a '74 350 4 bolt that hasn't ever been bored, planning on doing a .30 over and putting it back together. Problem is it has 76cc heads (my luck), I was hoping for more compression and still run on pump gas. So my question is should I go look for different heads or can I deck the block or mill the heads to get the compression up??? I'm putting it into a 91 c15 Jimmy, I'm looking for low end power, that's sort of a hot rod isn't it Looking for suggestions...
Lance
As a hobby I keep ten beehives. My queen bees are now getting older and slowing down, so I ordered ten more queens from an apiarist. They arrived, but there were eleven arrived in their containers....
the Official CHR joke page duel