I apologize for hoggin in on Clayton 55's thread and started this one. That said. I have two LT1's in the garage and am wondering if they would make good HR cruiser motors. They should be stock. I was told they had low (10,000) miles on them and I have had them for about 10 years. They are fbody motors with two bolt mains and alu. heads. Assuming the internals are good, clean them up, put new rings and bearings in them. I understand you can buy a carb and intake and use a conventional disti.. Can they be pepped up with the corvette cam using their current internals:confused? Is it worth the trouble.