Welcome to Club Hot Rod!  The premier site for everything to do with Hot Rod, Customs, Low Riders, Rat Rods, and more. 

  •  » Members from all over the US and the world!
  •  » Help from all over the world for your questions
  •  » Build logs for you and all members
  •  » Blogs
  •  » Image Gallery
  •  » Many thousands of members and hundreds of thousands of posts! 

YES! I want to register an account for free right now!  p.s.: For registered members this ad will NOT show

 

Thread: 1 liter per kilometer?milage
          
   
   

Reply To Thread
Results 1 to 11 of 11
  1. #1
    bdcain is offline CHR Member Visit my Photo Gallery
    Join Date
    Jun 2010
    Location
    winnipeg
    Posts
    10

    1 liter per kilometer?milage

     



    Hi all thanks for you time
    just got a 76 motorhome
    with a chevy chassis 1 ton i think (duellies in the back)
    worked nice at the farm when buying
    got down the road and died
    weak batt and bad gas /rusted fuel system
    after 2 days of guessing at the side of the road far away
    both tanks gone lines shot as it sat for 15 years if my calculatios are right
    anyhow i hooked up a outboard motor gas tank with a elec pump(was there)
    and new fuel filter and replaced the carb filter too
    and hooked it up directly to the manual fuel pump intake (the manual pump is there too)
    now i got 1 km per liter or 20bucks of gas for 20 kilometers
    or 20$ for 12 miles
    did the rest of the fuel go back into the rusted tanks in the bottom
    as the 2nd smaller line (? return line?)line was still conected to the manual pump?
    i really hope so or im in deeper than i thought! thanks a ton ?

  2. #2
    78c10 is offline CHR Member Visit my Photo Gallery
    Join Date
    Feb 2010
    Location
    sacramento
    Posts
    29

    i don't believe there IS a return line on 76 chevy vehicles. check the carb i think thats your best bet

  3. #3
    IC2
    IC2 is offline CHR Member Visit my Photo Gallery
    Join Date
    Sep 2007
    Location
    UPSTATE New York
    Posts
    4,336

    I have to say that some of those old motor homes were horrible on gas - with the 454 Chebbie being right at the top of the guzzler list - but a liter per km is horrible. Lets figure gas mileage in US so us Southerners can understand.

    20L=5.3 gallons. 12miles/5.3 = 2.2 mpg!

    First of all look at that carb. Stuck choke? Float full of gas? Dirt? Then next, the ignition. Is it advancing? Vacuum lines OK? Transmission shifting to drive? Spark plugs the right range? If all these are OK or can be repaired, and mileage doesn't improve much, then a compression check to get an idea of the internal condition is next.

    Most of these engines had a Q-jet on them. While they are good carbs, not known for economy on 454's

    Don't know how heavy/final gear ratio/what the frontal design is for that MH, but 7 to 9 mpg would be about normal for a carbed engine of that vintage in a MH. My 8000# F350 pulling my 11,000 5th wheel will vary from 7 to 10mpg, with normal about 9.
    Dave W
    I am now gone from this forum for now - finally have pulled the plug

  4. #4
    bdcain is offline CHR Member Visit my Photo Gallery
    Join Date
    Jun 2010
    Location
    winnipeg
    Posts
    10

    thanks
    well seller says the carb is brand new (and it looks clean enough to eat off of)
    and said he put in a new distributer and plugs !
    maybee he said wires too
    i will check into advancement and other possibilitys mentioned
    im shure the engine is tired
    could only get up to 60km with crappy batt
    then got over 70 km with a spare batt
    but didnt wan to push it as it sounded like a lifter? hitting the vallve cover?
    the sound was worse with the crappy batt it seemed to me
    thanks a ton

  5. #5
    jerry clayton's Avatar
    jerry clayton is offline CHR Member Visit my Photo Gallery
    Join Date
    Feb 2006
    Location
    Bartlett
    Posts
    6,831

    there were return lines on vehicles back in the 70s as part of emissionn stuff
    plug it off or maybe crimp the line flat---

    also the quadjet carbs had small primaries and to make any speed with heavy/large vehicles, drivers would have seconaries open and gas would be getting into intake however the air valve might not be open--

    454s back then got about 6 mpg-- and the compression was low so no power

  6. #6
    bdcain is offline CHR Member Visit my Photo Gallery
    Join Date
    Jun 2010
    Location
    winnipeg
    Posts
    10


    would this have anything to do with it?

  7. #7
    bdcain is offline CHR Member Visit my Photo Gallery
    Join Date
    Jun 2010
    Location
    winnipeg
    Posts
    10

    well after talking with the wife she IN favor of rebuilding /pepping up the engine

    can we rebuild it to get more power while using less gas or the same ?

    i see ready to go engines from 3 to 9 g
    or can i swap to diffent (newer )engine or diesil ?
    thanks a ton

  8. #8
    jerry clayton's Avatar
    jerry clayton is offline CHR Member Visit my Photo Gallery
    Join Date
    Feb 2006
    Location
    Bartlett
    Posts
    6,831

    whats the RV body like?? how big and what chassis??

  9. #9
    bdcain is offline CHR Member Visit my Photo Gallery
    Join Date
    Jun 2010
    Location
    winnipeg
    Posts
    10

    body is a eee
    or around 22 -23 feet counting spare
    the van body is in great shape
    and the rot in the corner of house part is a good day to properly reframe /skin etc
    will post pics of outside
    heres ones from inside



  10. #10
    jerry clayton's Avatar
    jerry clayton is offline CHR Member Visit my Photo Gallery
    Join Date
    Feb 2006
    Location
    Bartlett
    Posts
    6,831

    OK---if you want to do an swap---the modern 6.0 iron block out of the 2500 series have 6l90 trans---you would get pep and better milage----lots better milage!!!!!

  11. #11
    bdcain is offline CHR Member Visit my Photo Gallery
    Join Date
    Jun 2010
    Location
    winnipeg
    Posts
    10

    how much modification would be needed to swap out these engines
    what years should i be considering for the 6.0 iron block with 6/90 trans?
    i assume it would not be a s simple as plucking the old and dropping in the new one !
    what else would i need with the engine if i was to get a engine from the wrecker (electronics etc)
    also what would i expect to pay a pro to do it - engine cost
    thanks again

Reply To Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
Links monetized by VigLink