Looking for SBC intake bolt wedge / spacer

I'm aiming to place my 1984 350 SBC intake on my 1989 350 SBC engine.

The 89 engine was fuel injected and has the 4 center intake bolts are at a different angle. I'm looking for a better option on making the 28 degree wedges needed for making the flat bolt clamping surface.

My current plan is to work over a piece of hollow round stock (3/4" od 3/8" id) on the band saw at a 28-30 deg angle and the dress it by hand with a file.

The round stock pieces i have are 2" each and will require me to tack weld them to a piece of flat stock and then to clamp the flat stock in the band saw vice.

Early to Late model Intake Manifold Adapter Kit

http://www.holley.com/90748.asp

Installation Notes
Wedge Kit to install an early style Small Block Chevy Manifold ('86 and earlier)on Late Model Heads ('87 to '95 cast iron heads); Includes bolts and instructions
http://www.holley.com/data/products/...large90748.jpg

PowerCharger Intake Manifold Adapter Kit
Part #: 90748

AVAILABLE FOR PURCHASE
Price: $83.54 :CRY::CRY::CRY::CRY:


Too Rich for my blood ~ For $75 I'm buying another intake.

but $56.40 with free shipping on Amazon.com

I didn't know Amazon.com did hot Rod Chevy stuff...

http://www.amazon.com/Weiand-90748-M.../dp/B000LU8N4E

Still looking at making my own but $10 less and I'll be buying.

http://www.fastenal.com/catalog_pages/2005/0159.pdf

Square beveled washers are specially designed for
shimming and leveling in structural applications. Use with
American standard beams and channels that have 1:6 slope
(the same taper as a standard I-beam). Plain Malleable
washers are for general applications.
Beveled Washers
Malleable - Plain and Galvanized

Not perfect but close enough to work with, I'm grinding to slightly modify and narrow the shape. Also using a brass washer between the intake and the beveled washer.

you have a hack saw and a drill ? there not hard to make go and pick up some round stock or [] alum stock drill a25/64 hole in it cut your angle.some metal dealers have thick wall tubing you could use as well

Can these wedge kits be used in reverse for putting an 87 TBI intake on an 86 that was carbed? thanks

Quote:

---

Originally Posted by bikernut

Can these wedge kits be used in reverse for putting an 87 TBI intake on an 86 that was carbed? thanks

---

no you would need to slot it out and there will be no room for the bolts and spacers to go in at the new angle .you can buy or build a plate to bolt on the TBI to a old carb intake