Hey everyone,

My name is DJ, I have a 383lt1 and was ondering if someone could help me out with a cam and headwork selection.

For some basic info on the motor; its a 383 ni crank, forged 6" i-beam rods and forged flattop 11:1 comp. pistons.

Right now the heads are stock with a stock cam, but I want to run nitrous on a weekly basis. So here are the ideas Ive been toying with:

1) 1.6 rockers on the exhaust (to scavenge all exhast) with extreme port and polish, and aggressive cam with identical intake and exh. lifts.

2) stock 1.5 rockers with larger valves on the exhast with extreme port and polish and similar cam.

3) extreme port and polish with aggressive cam with higher exhaust lift than intake.

I would like to go with the full setup, 1.6 rockers, springs, valves, and porting, but my wife is limmiting my budget. I should also mention that I have 4.10 gears and a turbo 350 fully built with a 2500 stal. Also its carbbed

Any advice would be truly appreciated. Oh and I dont care about emmissions as this is a track toy.

Thanks everyone.