Thread: cross drilling 350 cranks?

Tweet

or can theses cranks handle over 6000 rpms already or do u have to cross drill them for better oil pressure or can u just get a high volume oil pump?

Originally Posted by redlinekink99

or can theses cranks handle over 6000 rpms already or do u have to cross drill them for better oil pressure or can u just get a high volume oil pump?

What cranks???

I know the Engine Guru's here will steer you straight (like Erik), but you might also read this:

rmre start

Originally Posted by 35WINDOW

I know the Engine Guru's here will steer you straight (like Erik), but you might also read this:

rmre start

Thanks for posting that info.....

Originally Posted by techinspector1

Thanks for posting that info.....

You are very welcome...so often I come here and do not have something helpful to Post, so I don't Post-it's nice to be of use-

a 350 crank

Originally Posted by redlinekink99

a 350 crank

Is the crank cast,forged steel etc??
We just need more info.

you do not need to cross drill a sbc crank you can use 3/4 mains or 360 full groove mains bearings for more oiling of the rods .the strait shot oiling is the best at very hi rpm cross drill can make things harder to oil and weakens the crank alot say a full 360 main will lower the load carring of the main bearing but have used them .i used the 3/4 in race engines but for lower rpm a stock main bearing works good like kings mich77 acls feds

I love articles like that ,nice ,simple and clear.

most likly a cast