Thread: Air gap manifold question

Tweet

This is a list from the Holley web site:

Holley Performance Street Performance – Traditional Products

Look at p/n 0-8007. It's a 390 CFM !!!!
* Vacuum Secondaries
* Power Valve Blow-out Protection
* 100% Wet-Flow Tested
* Model 4160 W/Side Hung Floats
* Calibrated for Small V8 or 6-cyl Engines
* 2x4 Street Tunnel Ram Carb
* Ford A/T Kickdown
* Electric Choke
* Includes Single Inlet Banjo Fitting

WOW,I never knew you could get a 4 barrel that small......
You could run those non progressive too!!!!!!!!
I think those are perfect for your engine...........
With the non tunnel ram intake and those carbs ,it should be a walk in the park.....

Originally Posted by shawnlee28

WOW,I never knew you could get a 4 barrel that small......
You could run those non progressive too!!!!!!!!
I think those are perfect for your engine...........
With the non tunnel ram intake and those carbs ,it should be a walk in the park.....

At $347 EACH from Summit .

Oh well it's only money. I used to run 750CFM 3310's and they are $270 ea and the good ol' 600 cfm 0-1850s are $250 ea

Thanks for all the replies.

I'm still in "thinking" mode on the engine for this project, but I know I want multiple carbs just for the look. I know, I know that's probably not a good reason, but you gotta admit, they sure do look cool.

My original plan was 3 dueces because I'm running a set on my 46 and know how to make them work. Price wise, either setup is about the same. Actually, the 2x4 may be a little cheaper.

The dual quads sound like a real challenge, but I'm crazy enough to take on a "lost cause" challenge every now and then.