need some engine advise....

i currently have a sbc 350 thats freshly bored .040 over with double bump heads 1.94 1.60 that have been done all new springs crane chrome moly full roler rockers, speed pro flat top 2 valve relief hyper techs with the teflon coating, holley strip dominator intake with a holley 600cfm vaccum secondary cam specas http://www.cranecams.com/?show=brows...tType=camshaft
its got 4.10 gears and a nv3500 trans mission its got 250 psi across the bored with an X pipe it just seems kinda weak and i was wondering if that was the best cam choice???

Gonna start with a basic question, did you just "slap" the cam in or put a degree wheel on it to make it right?

are you sure the valves are adjusted properly?

[QUOTE=DennyW] relieve the exhaust side of the ports,QUOTE]

what do you mean by that ya lost me??