I bought a jegs 350 crate engine, and ive bought so many started and none of them will meet up with the flywheel there is like a quarter inch differenmce PLEASE HELP!! ASAP... If u know a make and model of a car starter i can get help me please
Printable View
I bought a jegs 350 crate engine, and ive bought so many started and none of them will meet up with the flywheel there is like a quarter inch differenmce PLEASE HELP!! ASAP... If u know a make and model of a car starter i can get help me please
There are two starters for the Chevy. One has the mounting bolts straight across from each other. Use that one with the 153 teeth flywheel / flexplate. The other has offset mounting bolts and is for use with the 168 teeth flywheel / flexplate. Sounds as though you have the offset bolt starter and a 153 teeth flexplate. That would account for the drive not reaching the flexplate teethQuote:
Originally Posted by Shavenlaidblaze
Bob
From Gilbert Chevrolet:
Flywheels/Flexplates with two different diameters are used on Chevrolet small-block V8, big-block V8, and V6/90° engines. Large flywheels/flexplates are 14” in diameter, and have 168 teeth on the starter ring gear. Small diameter flywheels/flexplates are 12-3/4” in diameter and have 153 teeth on the starter ring gear. Flywheels are used on manual transmissions and flexplates are used on automatic transmissions.
The difference in flywheel/flexplate diameters requires two distinct starter housings. Starter noses used with large diameter flywheels/flexplates have two offset bolt holes; starters for small flywheels/flexplates have two bolt holes which are parallel to the back of the block. Most Chevrolet blocks are drilled for both types of starters. If you are changing the diameter of your Chevrolet’s flywheel/flexplate, you can convert your present starter to fit the new flywheel/flexplate by installing the appropriate starter nose, starter motor housing, found within each engine classification.
01968122 - Starter Nose. For 12-3/4” diameter flywheels.
Technical Note: Used with starter P/N 10496870. Bolt holes are straight across.
00354353 - Starter Brace 153 Tooth. Braces greatly reduce the load on the starter nose.
10465143 - Starter SBC and BBC, light weight, high-performance, Remanufactured. Used originally on Camaro Z28’s with LT1 engines, but can be used on any small-block or big-block Chevrolet engine with 12-3/4” flywheel. Price includes core charge.
Don't forget......One piece rear mains are different from two peice in diameter. Look up inside the flexplate area and see which you have. Aluminum seal holder is a one piece, Standard cast cap like the old days is a two piece. Crate motor? high probability it's a one piece rear. If it is, any small block starter starting from '86 will do. Keep your preference in the late '80's to insure the proper fit.
Ok guys i fingered it out.. i need the starter with the bolts straight across.. thanx guys worked perfect.. Im needed a little help on a good cooling system,... What u guys reccomend for an s10 and will fit?>?