Printable View
I have my 462's ready for the shop again to install head studs for my roller rockers. I see they come two differnt ways, a 7/16 bottom, and choice of 7/16 or 3/8 top (or rocker side), is there any difference in them other than the obvious 7/16 size is bigger and stronger? Like interference problems. No I have not bought my rollers yet obviously. Thanks. The new baby is due in two or three weeks, and Im tyring to get as much done before I'm sidelined for awhile.:LOL:
Are you asking about head studs or rocker arm studs?Quote:
Originally Posted by jimmyjeep
If you are asking about rocker arm studs I go to a 7/16'th's after .525 lift in a sbc.
Eric I was talking about rocker arm studs. Thanks for the reply.
Are you saying that up to .525 I could use rockers with the original press ins?
462 SMALL BLOCK heads:eek: sorry/////???? i will go back to working on my big block:D all big blocks are 7/16 on the top ALL OF THEM were the rock mounts BUT THERE IS MARK 5/6 heads that have 3/8 at the bottom of studs i drill them for old style 7/16 top and 7/16bottom that treads in the heads :3dSMILE: if you are running your small block hard i would go to the 7/16 studs for your small block.i was thing this was a big block?
Well I thought about installing them myself, but I really have no way of cutting the bosses down accurately enough. I think their suppose to be cut to .250, but I have my doubts on how close I could get in the garage at home. Thanks Pat, how much should this cost me, ?
mill the studs towers down for studs and guide plates and tap them i get $75
How come you have to be on the other side of the state???????