Thread: Timing Belt
Hybrid View
-
12-22-2006 03:29 PM #1
My cousin said the same thing. It's an interference motor soooo in other words if it's out of time. Boom. Valves smashed, pistons destroyed, etc etc. I'm trying to find a damned chilton's book on it but no one stocks them around town.. it's got 78,000 on the motor and the belt's never been changed. I had someone look at it with a mirror, said it had cracks, not deep ones but it's cracked nonetheless. So. I need a book NOW.
-
12-22-2006 04:27 PM #2
Best thing to do is get a shop manual specific to your car, preferraby published by Mazda, and not a third party. That will provide you not only how to info, but all specs (like torque) and tools needed. You will need something to lock down the camshaft(s) so they don't move when replacing the belt. If your water pump is located under the cover with your belt, you probably should replace it as well so you won't have to tear the engine apart a second time to replace it. (Standard procedure on Honda's, don't know about Mazda's). I have done the job on a Suziki Tracker twice, not a major job on that vehicle, and once on a Subie, again not a major job. Neither of those vehicles required replacement until over 100k miles.
With a little skill you should be able to get it done in a few hours.
-
12-22-2006 04:37 PM #3
Originally Posted by mopar34
I don't understand the whole idea behind holding the camshaft down. if the camshafts on top of the valves and the valve springs keep pressure on the cam.. why should it move? or is it more complicated than that in a DOHC motor? >_>
-
12-22-2006 04:56 PM #4
mark the pulleys at least with corresponding marks on the block so you can make sure everything is RIGHT where it was before.
-
12-22-2006 05:34 PM #5
depending on spring presurres and cam positions the cams will want to roll a degree or so when you take the belt off.... a degree or so wont be enough to cause a trainwreck, but it definately wont run as well.... and yes that car is a pain in the bum.... i've done a few in the shop.... takes me about an hour and a half to 2 hours to get the job done.... but it pays 5just because your car is faster, doesn't mean i cant outdrive you... give me a curvy mountain road and i'll beat you any day
-
12-22-2006 10:10 PM #6
HOW do you block them from moving? How did you do it Thesals?
-
12-23-2006 12:30 AM #7
i get everything taken apart and ready to go except for the belt taken off and then i get a lube tech to use a prybar to hold the pulleys in place while i slip the new belt onjust because your car is faster, doesn't mean i cant outdrive you... give me a curvy mountain road and i'll beat you any day
The main function of your little toe is to make sure all the furniture in the house is in the right place.
the Official CHR joke page duel