Thread: Looking for ideas.
-
08-31-2006 10:20 AM #1
Looking for ideas.
Hello all. Great forum! I am looking for head/cam ideas for the following -
I have in my posession -
- .060 over 4 bolt 350 block, just back from machine shop
- .060 over KB Hypereutectic Pistons, (KB114's for a 6 inch rod, .388 dome, listed CR is 12.9 w/ 64cc 10.9 w/76cc head)
- Stock 400 crank and rods.
The vehicle this will be for is an '85 S10, 3300lbs. Already in the truck is a 3200rpm converter, 4.56 gears using 31" tall tires, and good headers.
This truck will get VERY little street duty, meaning race fuel is not a problem. I look forward to your head/cam suggestions.
-
Advertising
- Google Adsense
- REGISTERED USERS DO NOT SEE THIS AD
-
08-31-2006 02:19 PM #2
Well, let's get squared away on the rods first. You say you have KB's for a 6" rod, then you say you have stock 400 rods. Stockers are 5.565", so your KB pistons won't work with them.
WAZZUP???????PLANET EARTH, INSANE ASYLUM FOR THE UNIVERSE.
-
08-31-2006 02:43 PM #3
Originally Posted by nurkvinny
-
08-31-2006 02:45 PM #4
12.9 CR is a bit much for pump gas. that fancy $6.00 a gallon VP110 gets expensive. But for my Money, 64 cc World Products heads, ISKY 547-A Mechanical Flat tappet cam.
Edelbrock Victor JR on Alcohol. I ran this combo a couple years back in a 383. It was a great combo. I only run Roller cams now. If your budget will allow, there are some good ones out there.
-
09-01-2006 09:39 AM #5
Thanks for the replies so far.
I will have to re-measure the rods tonight. I am all but certain that they were 6".
All true wisdom is found on T-shirts. If at first you don't succeed, redefine success. I don't have a solution, but I do admire the problem. If a thing is worth doing, it would have been...
the Official CHR joke page duel