Thread: Looking for a little advise........

Tweet

well my current motor is a 350 60 over with my 400 crank. I have a spun bearing. It doesnt nock on moving the RPMS up but when it comming back down.
It is a 1980 target block! and im pretty sure its not a 4 bolt, In fack I know its a 2 bolt, and I really dont want to use it again......
stock heads performer rpm intake, holly 650 dp, headman headers,comp cam Duration 250/ 258, Lift .432/ .453, 4x4 cam

The 305 is a early 90 z28 motor. It is a roller motor! So I was always told that the 305 heads were really restricting on these motors, so I figure Id use my fresh double humps 202/160s, my 400 crank "if its not all scared up" and go fuel injection and build somthing that wont be as easy to distroy but still make some power????

I want to do this fairly inexpensivly. I have the 305 short block. I have the 400 crank. I have all the fuel injection stuff, and I have the double hump heads. So I want to use what I have with out buying a ton and still make something fun to drive.