Printable View
i bought a chevy V8 msd ignition kit.
MSd ignition 6AL
Blaster 2 Coil
Pro Billet Distributor
MSD 8.5 mm wires
I installed everything. Read and folowed all directions. I have power and my 12 volt ignition source hooked up...but no power to the coil. I think its fault. Any ideas?
Well, over the years I've had two boxes, one 6AL and a 7 bad out of the box.... No problems with MSD on the warranty, though.
I am a little sleepy, so i may be off base here.
Are you not getting 12 to the positive side of the coil or not getting pulse on the neg side?
My problems with MSD boxes have always been that I loose pulse from the box to the neg side.
I have power to the ignition box and my 12 volt source to the ignition box. but i have nothing at the positive or negative side of the coil. Theres nothing coming out of the ignition box to the coil.
Could be so if ya got power to the 6al then have someone crank theengine and check for flucuating power at the coils positive wire or yank a plug wire to check for spark .
Ive used the 6al and msd distrubitor with bad luck 2 times usually the 6 al box oes bad on me
turn key on find the with white wire touch to ground . it will spark thru the coil if the box is good from the coil wire . have it by some thing grounded and you should have a spark you need 12 volts thru the big red wire and you need 12 volts switch. i do not think you will see any spark you need to make the box discharge the box and the with white wire will do this it is a breaker wire if no spark it could be the dist .the hook up on the dist need to be un hook to do this. i think this is right but check with msd i have had good luck with msd stuff. they make very fine stuff
tried it. thanks though. must be the box...2 out of 3 people here said theres goes bad also... MSD might wanna check that out. i could of went to autozone and a new distributor and coil for less then $180 instead of MSD kit for $550.
had one go bad in ten years .yes they do go bad i sent one in and they fixed it for free. but i still think they make fine stuff. dist and crank trigger stuff to. what is hard on this stuff is moister .i had one of there all in one dist went bad but from setting and rusted all up