Do I have the correct gaskets?

Picked up a set of Mr. Gasket ultra-seal intake gaskets today. I noticed that the gaskets are solid where the smaller center ports are located. Only have the bolts holes there. Will these work?

The packaging states for 1987-1995 Gen I SBC.

Application heads:

14101083...1987-up...350..........Gen.I, also used on crate motors, 285 or 300 hp, 64cc chambers, 72' center manifold bolt angles. (Mortec.com)

Hope someone can help with this.

The attachment is a diagram of the suspect area..:whacked:

Quote:

---

Originally Posted by DennyW

If you do not want heat to go to the intake, these will work.

---

Thanks Denny,
Will the electric choke on the Edelbrock(1406) still function as it should? Does the choke need this heat? I could cut out the area if need be. Would rather install as they are if I can.

I am curious, would blocking these have any performance advantages?

Thanks for helping out Denny.:)