questions about supercharging a 350 sb

I have a question about supercharging a 350 sb it has 10.1:1 cr. what would be a safe psi to run?

If I was building a blower motor, the compression would be in the low 8's. With 10:1, detonation is a big probelm. Why bother with a blower if you can't put some pullys on it that will build some boost ???

thanks for the reply i also have another question. I've looked at weiand blowers that cast around 2300 dollars but is there any additional cost/parts that u have to buy on top of that?

Quote:

---

Originally posted by Lil_Phil
thanks for the reply i also have another question. I've looked at weiand blowers that cast around 2300 dollars but is there any additional cost/parts that u have to buy on top of that?

---

IF YOU BUY THE KIT FORM THE ONLY THING LEFT WOULD BE THE CARB. LINKAGE.ALSO CHECK OUT BDS BLOWERS THEY HAVE A 12 MONTH WARRANTY ON THEM AND SELL FOR $2,400.

I agree with Eric, given the choice I would go with the BDS unit. Had one on a BB Ford and loved it!!!

ok thanks

watch out to much boost make heat to 9 to1 and not run the blower so hard works very good

Here's a chart from Blower Drive Service showing the max boost you can use on pump gas with which static c.r. .....
http://www.blowerdriveservice.com/techcharts.php