Originally posted by Horse
Hello Mike,
I don't know what you mean by codes. My "Service Engine Soon" warning light doesn't come on, if that's what you mean.
BTW. I admire your site.. very impressive.
thanks horse, there is a place that you can plug a scanner to on your veh.(sitting in the drivers seat should be under the dash about knee high it will have 12 pin holes and only 8 pins) and get the codes. facing the plug or DLC its the 2 top right hand side pins. side by side jump them and it should give you a code 12 if its ok. it will flash the "SERVICE ENGINE" light. if your service engine light dont flash then its like denny said the fuse might be blown and thats the problem. if you get a code let me or denny know and well tell you what it is.


Turn ignition switch to OFF position
Locate Data Link Connector (DLC), .
Jumper the A&B terminals(a paper clip or a jumper wire work ok)
Turn Ignition switch to ON position.
Count the flashes on the "CHECK ENGINE" or "SERVICE ENGINE" light.
FLASH, pause, FLASH, FLASH = code 12
NOTE: Some 94 & 95 models do not have the B terminal. In which case a scanner is required.
NOTE: Some 94 & 95 models that DO have the A & B terminals still require a scanner.

12 Pin DLC
A - Ground F - TCC
B - Test Terminal G - Fuel Pump
C - Air Injection H - Brake Sense Speed Input
E - Serial Data M - Serial Data