think this stud will hold?

Well i drilled an offset hole :(, just curious if you guys think this headstud will hold under normal driving conditions???

http://i19.photobucket.com/albums/b1...estview379.jpg

No Way!! Need different head!

Ditto on the ''NO''. Rocker arm won't line up right either.

Nope, get a different head.

doubt it...how'd that happen?

Heat it up to 1200 degrees, fill it with bronze, slow cool over 24 hours, and try again.

lol.......long story..............well i had the engine reconditioned by the owner b4 i bought it, he put a mild cam in it but not new lifters. So after realizing my car was missing lots of power i finally popped the valve covers to see if the rockers were tight. One was all loose and a few others werent too tight. So i tightened them up, and made some carb adjustments. Soon after the problems got worse and worse. Anyways to make a long story short i pulled the intake mani and noticed my lifter on the other side of the engine and a head stud pulling out. I cut it and began drilling a hole. but it went the wrong direction-lol. Its cool tho im gettin a remanufactured head for 150:)