Thread: 350 streetrod rebuild
-
05-03-2005 09:12 PM #1
350 streetrod rebuild
I'm rebuilding motor for my 66 Chevy PU. Would like opinions on best cam choices for my app. -- Prefer a noticeable idle but more concerned about performance over a broad range. Considering Comp 270H - 224 dur, .470 lift, 110 sep angle
Comp 268H - 218 dur, .454 lift, 110 sep angle
or Isky 270 Megacam - 221 dur, .465 lift, 108 sep angle
280 MegaCam - 232 dur, .485 lift, 108 sep angle
P.A.W. ISS also has one for about half the price with near same specs but sep angle is 114 unless I go to a much lower lift
Bore - .040 over
Stroke - Stock
Pistons - 4-relief flat top
Heads - late model '87-'93 cast iron (64cc?)
Intake - Edelbrock Performer
Carb - Q-Jet aftermarket mild performance
Exhaust - round-tube header, dual Cherrybomb glasspack, 2-1/2 in pipes
Tranny - 4 speed
Rear gears - 12 bolt probably stock, not sureLast edited by notdeadyet; 05-03-2005 at 09:15 PM.
-
Advertising
- Google Adsense
- REGISTERED USERS DO NOT SEE THIS AD
-
05-03-2005 10:28 PM #2
I called comp and isky and both were more than helpful!!They both asked alot of questions , told them exactly what my intended use was and they made good recomendations.Its gunna take longer than u thought and its gunna cost more too(plan ahead!)
-
05-08-2005 06:25 PM #3
I took ShawnLee's advice and called P.A.W. then Comp Cams. Both were very helpful. I've ordered the Comp Magnum 270H.
On a bitterly cold winter morning a husband and wife were listening to the radio during breakfast. They heard the announcer say, "We are going to have 8 to 10 inches of snow today. You must park...
the Official CHR joke page duel