Printable View
Hello, I'm rebuilding a 396 from a 1966 Impala SS. I have the manual and the only torque specs I see for the rocker arms, is for the Rocker Arm Stud, which is 50ft lbs.
Can anyone advise on what the torque specs are for the rocker arm nut? I don't want to get it to tight or to loose.
Thanks
I never set lifters by torque. Check this page:
Engine Valve Adjustment Procedure - The Right Way
good info there, here is what i gathered from thatQuote:
Originally Posted by Henry Rifle
". When you feel resistance in the pushrod as it applies pressure to the socket in the rocker arm and lifter - STOP, now you will adjust the nut down "Only" 1/8-1/2 turn further. If you operate your engine a consistent high RPM, use the slightly lighter setting of (1/8 turn)."
Quote:
Originally Posted by Henry Rifle
Good info there, here is what i took away from it. Is this correct?
"When you feel resistance in the pushrod as it applies pressure to the socket in the rocker arm and lifter - STOP, now you will adjust the nut down "Only" 1/8-1/2 turn further. If you operate your engine a consistent high RPM, use the slightly lighter setting of (1/8 turn)."