Hello, I am new here and figure after reading numerous threads someone might be able to help me out. I am building a 402 for bracket racing. This is my first bbc build, im a die hard sbc guy but the price was right. I aquired a freshly rebuilt engine carb to pan, but its a stock rebuild. The heads are 241 w/ stock valves and a fresh valve job. The short block is stock w new rings and bearings, it wasnt decked.

My plan so far is to use the shortblock the way it is.
comp cams magnum 292
victor jr o w/ worked 750 holley

I have a set of good 820 castings that im port / polishing and going to have 2.19-1.88 valves installed. Is angle milling an option to raise compression. Will this set up make decent power.

Are the 241 heads an option w/ the stock valves?

I know there is more info needed but not quite sure what is relevant.

Thanks,
John

"bbc newbie"