Thread: Need 402 help
Threaded View
-
01-29-2010 01:11 PM #1
Need 402 help
Hello, I am new here and figure after reading numerous threads someone might be able to help me out. I am building a 402 for bracket racing. This is my first bbc build, im a die hard sbc guy but the price was right. I aquired a freshly rebuilt engine carb to pan, but its a stock rebuild. The heads are 241 w/ stock valves and a fresh valve job. The short block is stock w new rings and bearings, it wasnt decked.
My plan so far is to use the shortblock the way it is.
comp cams magnum 292
victor jr o w/ worked 750 holley
I have a set of good 820 castings that im port / polishing and going to have 2.19-1.88 valves installed. Is angle milling an option to raise compression. Will this set up make decent power.
Are the 241 heads an option w/ the stock valves?
I know there is more info needed but not quite sure what is relevant.
Thanks,
John
"bbc newbie"
John's ride to the cemetery, his beloved Billings OK bus, The Baby Elephant!! Traveling in style!! As his service was starting I couldn't figure out what the music was, heavy on a flute in a jaunty...
John Norton aka johnboy