I'm working on my 1st carb motor (lots of lsx and ltx stuff in the past). Its a 498 with a 6/71 blower on top. I have Holley 950 blower specific carbs on it. I'm not sure if I hooked the linkage up correctly, because when I open the throttle one side of each carb opens then about 1/2 throttle the other side opens. At WOT both sets of butterflys are 100% open. So is the linkage right or do I need to adjust so both sides of the carbs open even?

Hope this makes it more clear

carb 1 0-0 (both open at any throttle) carb 2 0-0 (same as carb 1)
carb 1 0-0 (closed till 1/2 throttle) carb 2 0-0 (same as carb 1)


Jason